Want to know Ucertify ccna wireless 200 355 dumps Exam practice test features? Want to lear more about Cisco Implementing Cisco Wireless Network Fundamentals certification experience? Study Vivid Cisco ccna wireless 200 355 answers to Renovate 200 355 wifund questions at Ucertify. Gat a success with an absolute guarantee to pass Cisco cisco 200 355 (Implementing Cisco Wireless Network Fundamentals) test on your first attempt.

Q61. Refer to the exhibit. The site in this AirMagnet Survey heat map is ready for which level of service? 

A. data 

B. voice 

C. location 

D. RFID 

Answer:


Q62. Which option is needed to earn the Cisco Compatible credential for Cisco Compatible Extensions Lite? 

A. Foundation and Management are required. 

B. Location and Management are required. 

C. Foundation and Location are required. 

D. Foundation and Voice are required. 

E. Voice is required. 

F. Foundation is required. 

G. Location is required. 

H. Management is required. 

Answer:


Q63. What encryption standards describe WPA and WPA2? 

A. WPA mandates AES with TKIP optional, WPA2 mandates TKIP 

B. WPA mandates TKIP with AES optional, WPA2 mandates AES 

C. WPA mandates CKIP, WPA2 mandates AES 

D. WPA mandates CKIP with AES optimal, WPA2 mandates AES 

Answer:


Q64. Which information on the Monitoring page of a Cisco WLC verifies that the wireless network is operational? 

A. In the Access Point Summary section, the All APs number in the Up column is the same as in the Total column. 

B. In the Client Summary section, the Current Clients number is positive. 

C. In the Controller Summary section, the 802.11b/g Network State is shown as Enabled. 

D. In the Controller Summary section, the CPU Usage number is positive. 

Answer:


Q65. When using multiple SSIDs on a lightweight AP, how does the traffic of each SSID reach the 802.3 network? 

A. provide routing between them at the core so that the SSIDs can reach the internet 

B. configure 802.11q trunking on the Ethernet switch port that is connected to the AP 

C. configure ACLs at the switch port that will allow all desired SSIDs to pass traffic 

D. configure the SSIDs on the WLC and it will regulate the traffic based on traffic type 

Answer:


Q66. The introduction of consumer phones and tablets into enterprise WLANs can have an impact on 802.11a/b/g/n deployments. The Apple iPhone 4 and iPad 2 are very common examples. 

Which statement best describes the abilities of these devices? 

A. The Apple iPhone 4 and the iPad 2 use 2.4 GHz and 5 GHz. The Apple iPhone 4 uses only one spatial stream and the iPad 2 uses two spatial streams. 

B. The Apple iPhone 4 uses only 2.4 GHz and the iPad 2 only uses 5 GHz. The Apple iPhone 4 uses only one spatial stream and the iPad 2 uses two spatial streams. 

C. The Apple iPhone 4 uses 2.4 GHz and the iPad 2 uses 2.4 GHz or 5 GHz. The Apple iPhone 4 only uses one spatial stream and the iPad 2 uses two spatial streams. 

D. The Apple iPhone 4 uses 2.4 GHz and the iPad 2 uses 2.4 GHz or 5 GHz. The Apple iPhone 4 and the iPad 2 use only one spatial stream. 

Answer:


Q67. A customer wants to deploy Cisco Cloud Wireless architecture with 802.11ac capabilities. 

Which access points would meet the customers’ requirements? (Choose two.) 

A. Cisco 3700 Access Points 

B. Cisco MR34 Access Points 

C. Cisco MR18 Access Points 

D. Cisco 3600 Access Points 

E. Cisco MR72 Access Points 

F. Cisco 1570 Access Points 

G. Cisco MR26 Access Points 

Answer: B,E 


Q68. Which three AP modes of operation allow for the wIPS sub mode? (Choose three.) 

A. local mode 

B. bridge mode 

C. monitor mode 

D. H-REAP mode 

E. rogue detector mode 

F. SE-Connect mode 

G. sniffer mode 

Answer: A,C,D 


Q69. Which two actions are best for deploying VoWLAN on a wireless network? (Choose two.) 

A. Minimize the use of Class 3 Bluetooth devices. 

B. Minimize the use of analog cameras. 

C. Minimize the use of IP cameras. 

D. Maximize client access by enabling all data rates used by clients. 

E. Maximize client access by enabling only a few high data rates used by clients. 

Answer: B,E 


Q70. The AP is unable to join the WLC. What switch configuration will correct this problem? 

A. interface vlanl ip helper-address 10.10.10.10 

B. interface vlan20 ip helper-address 10.10.10.10 

C. ipdhcp pool vlanl option 43 ascii '10.10.10.10' 

D. ip dhcp pool vlan20 option 43 ascii '10.10.10.10' 

E. ipdhcp pool vlanl option 43 hex f1040a0a0a0a 

F. ip dhcp pool vlan20 option 43 hex f1040a0a0a0a 

Answer: