Proper study guides for Improve Cisco Implementing Cisco Wireless Network Fundamentals certified begins with Cisco 200 355 wifund preparation products which designed to deliver the Pinpoint 200 355 wifund pdf questions by making you pass the ccna wireless 200 355 official cert guide pdf test at your first time. Try the free 200 355 vce demo right now.
Q141. The wireless network is using controller-based APs and version 7.0 MR1. The APs appear to be connected properly to the controllers. A wireless user near one of the APs reports that they are unable to connect to the network with their pre-shared key.
Which option shows the GUI path where you can check the connection status of that client?
A. WLANs > WLAN_ID > Advanced
B. Security > Clients
C. Security > Advanced > Clients
D. Monitor > Clients
E. Wireless > 802.11b/g/n > clients
Q142. Refer to the exhibit.
Which two statements about the status of the respective AP on a Cisco WCS version 7.0 map does this icon represent? (Choose two.)
A. The 802.11a/n radio is administratively disabled.
B. The 802.11a/n radio has a minor fault.
C. The 802.11a/n radio has a major fault.
D. The 802.11b/g/n radio is administratively disabled.
E. The 802.11b/g/n radio has a minor fault.
F. The 802.11b/g/n radio has a major fault.
Q143. Which two statements best describe the LAG configuration between a Cisco WLC and a Cisco Catalyst switch? (Choose two.)
A. The Catalyst switch should be configured for PAgP.
B. The Catalyst switch should be configured only for Layer 2 load balancing.
C. The Catalyst switch should be configured for "on" mode.
D. The Cisco WLC relies on the connected switch to perform the load-balance of traffic.
E. The Cisco WLC aggregates multiple management interfaces into a single virtual interface.
Q144. After installing a Cisco 5508 Wireless Controller using the default settings, how often will the RRM update occur?
A. 30 seconds
B. 60 seconds
C. 300 seconds
D. 600 seconds
E. 3600 seconds
F. 7200 seconds
Q145. When the pre-shared key authentication method is used for WPA or WPA2, for which two functions is the pre-shared key used? (Choose two.)
A. to act as the Group Transient Key during the bidirectional handshake
B. to act as the Pairwise Master Key during the bidirectional handshake
C. to derive the nonce at each side of the exchange
D. to derive the Pairwise Transient Key
Q146. Which path do you take to manage the results of a report that had been run on network utilization?
A. Reports > Report Launch Pad > Device > Utilization
B. Reports > Report Launch Pad > Scheduled Run Results
C. Reports > Saved Reports > Scheduled Run Results
D. Reports > Scheduled Run Results
Q147. An engineer has been asked to upgrade the FUS on the Wireless LAN controller. How can they monitor the status of the upgrade?
A. WLC GUI
B. WLC CLI
C. WLC Console
D. WLC Management in Prime Infrastructure
Q148. What AnyConnect module can be used to provide a detailed scan list of the Wi-Fi environment?
C. Web Security
Q149. An AP using version 7.0 MR1 broadcasts a Layer 3 CAPWAP discovery message on the local IP subnet. Which step does the AP take next?
A. Determine if the controller responses include the primary controller.
B. Determine if the controller responses include the master controller.
C. Send a discovery request using DHCP option 43.
D. Send a discovery request using DNS.
E. Send a discovery request using locally stored information on the AP.
F. Send a discovery request using OTAP.
Q150. RAG DROP