Master the 200 355 wifund pdf Implementing Cisco Wireless Network Fundamentals content and be ready for exam day success quickly with this Actualtests ccna wireless 200 355 official cert guide pdf free question. We guarantee it!We make it a reality and give you real ccna wireless 200 355 pdf download questions in our Cisco 200 355 pdf braindumps.Latest 100% VALID Cisco ccna wireless 200 355 official cert guide pdf Exam Questions Dumps at below page. You can use our Cisco ccna wireless 200 355 pdf braindumps and pass your exam.

Q151. A network engineer is upgrading the WLC image through the GUI for maintenance. What three transfer methods are available? (Choose three.) 

A. FTP 

B. SNMP 

C. TFTP 

D. SFTP 

E. HTTP 

F. SMB 

G. HTTPS 

H. SCP 

Answer: A,C,D 


Q152. Which interface is used to connect the foreign and anchor controllers? 

A. management 

B. service 

C. virtual 

D. dynamic 

Answer:


Q153. An engineer assists a user in configuring an Android device for authentication to an IEEE 802.1x EAP WLAN with PEAPv1. The Phase 2 authentication should be configured as which option? 

A. LEAP 

B. MSCHAPv2 

C. TLS 

D. TTLS 

Answer:


Q154. Which two items are needed to discover the IP address of a new Cisco Aironet 1260 autonomous AP that just finished booting? (Choose two.) 

A. username = "cisco" and password = "cisco" 

B. username = "Admin" and password = "Cisco" 

C. username=Cisco and password=Cisco 

D. show int vlan1 

E. show int bvi1 

F. show int gigabitethernet0 

G. show int radio0-802.11n 

H. show int radio1-802.11n 

Answer: C,E 


Q155. An engineer wants to deploy a 2504 controller as the anchor controller for a guest WLAN that resides on a 5508 controller in a different mobility group. What configuration change must be applied to support this deployment strategy? 

A. UDP 16666 and IP Protocol 97 must be enabled on the 2504 controller 

B. UDP 5246 and TCP Protocol 97 must be enabled on the router 

C. The 2504 controller must be added to the same mobility group as the 5508. 

D. DHCP Option 43 must be added to the neighboring switchport 

Answer:


Q156. An AP has been configured for personal wireless access to the Internet. 

Which item should be configured on the wireless client? 

A. RF channel 

B. BSS 

C. PSK 

D. 802.1X/EAP 

E. broadcast SSID 

F. IBSS 

Answer:


Q157. Which Cisco AnyConnect module provides wireless connectivity? 

A. telemetry 

B. web security 

C. VPN 

D. NAM 

E. DART 

F. posture 

G. CSSC 

Answer:


Q158. When using the CLI command eping, configured for auto-anchor mobility wireless guest access, which type of packet is tested? 

A. data packets 

B. mobility unencrypted packets 

C. mobility encrypted packets 

D. SNMP control packets 

E. NTP control packets 

Answer:


Q159. An 802.11g network is experiencing intermittent signal degradation and Spectrum Analyzer is being used to try and locate the problem. What two interferers would likely be identified? (Choose two.) 

A. multiple cell phones 

B. microwave oven 

C. FM Radio 

D. cordless phone 

E. document scanner 

Answer: B,D 


Q160. What must be done for Cisco WLC and Cisco WCS to communicate? 

A. The IP address and subnet mask of the Cisco WLC must be configured in the Cisco WCS. 

B. The IP address and subnet mask of the Cisco WCS must be configured in the Cisco WLC. 

C. The identity certificate of the Cisco WLC must be added to the Cisco WCS. 

D. The Cisco WLC and Cisco WCS must exchange identity certificates. 

Answer: