Act now and download your Cisco 200 355 pdf test today! Do not waste time for the worthless Cisco 200 355 vce tutorials. Download Updated Cisco Implementing Cisco Wireless Network Fundamentals exam with real questions and answers and begin to learn Cisco 200 355 vce with a classic professional.

Q191. What are three characteristics of WCS? (Choose three.) 

A. based on a single server licensing system 

B. used for wireless planning 

C. used for real-time tracking of multiple clients 

D. used for wireless management 

E. used for RF fingerprinting 

F. based on a per server licensing system 

Answer: A,B,D 


Q192. RAG DROP 

Answer: 


Q193. Mac OS X machines are having issues accessing the wireless network. While working with TAC, the administrator is asked to find the Mac laptop's wireless adapter model and driver. Where should the administrator look to find this information? 

A. About This Mac > System Report 

B. Control Panel > System 

C. System Preferences > Network > Wi-Fi Adapter > Advanced 

D. Control Panel > Networking > Adapters > Properties 

Answer:


Q194. Which description best describes upfade in a multipath environment? 

A. In this situation, multiple signal paths are not sent at exactly the same time. The receiver receives a positive crest on the primary signal and a negative crest on the secondary signal. 

B. In this situation, the multiple signal paths are distorted and difficult to understand. 

C. In this situation, the multiple signal paths are weaker than they should be because the signals are out of phase with each other. 

D. In this situation, the signal is stronger than it should be because multiple signal paths are received twice at exactly the same time, which results in the multiple signals being in-phase. 

Answer:


Q195. Refer to the exhibit. In WCS, what Monitor submenu would provide the table shown? 

A. Clients 

B. Access Points 

C. Controllers 

D. Security 

E. Alarms 

Answer:


Q196. An engineer wants to setup WPA2 Enterprise using EAP-TLS and a remote RADIUS server. What device(s) would the engineer specify the EAP type on? 

A. the supplicant and authentication server 

B. the supplicant and authenticator 

C. the authenticator and authentication server 

D. the supplicant only 

E. the authentication server only 

Answer:


Q197. Which statement correctly describes the procedure for a lightweight AP to successfully establish a connection to a controller? 

A. The AP authenticates the received Cisco WLC certificate as valid. The AP then sends its certificate to the controller. 

B. The AP sends its certificate to the controller. The AP then authenticates the received Cisco WLC certificate as valid. 

C. The AP sends its certificate to the RADIUS server. The AP then authenticates the controller certificate as valid. 

D. The AP sends its certificate to the RADIUS server. The AP then authenticates the RADIUS certificate as valid. 

E. The AP authenticates the received RADIUS server certificate as valid. The AP then sends its certificate to the RADIUS server. 

F. The AP authenticates the received RADIUS server certificate as valid. The AP then sends its certificate to the controller. 

Answer:


Q198. Which type of basic radiation pattern does a Yagi antenna have? 

A. circular 

B. semicircular 

C. straight line 

D. cone 

Answer:


Q199. Which three Cisco Unified Wireless Network capabilities use information that is provided by Radio Resource Management neighbor messages? (Choose three.) 

A. aggressive load balancing 

B. dynamic channel assignment 

C. hybrid remote edge access point 

D. inter controller mobility (that is, mobility groups) 

E. over-the-air provisioning 

F. rogue AP classification 

Answer: B,E,F 


Q200. The network administrator has used VLANs to separate VoIP frames from data frames in the wired network. What must the administrator use to separate those frames in the wireless network? 

A. multiple SSIDs 

B. multiple authentications 

C. multiple WEP or WPA keys 

D. multiple channels 

E. multiple 802.11 radios (a, b, g, n) 

Answer: