Master the 300 320 dumps Designing Cisco Network Service Architectures content and be ready for exam day success quickly with this Examcollection 300 320 dumps question. We guarantee it!We make it a reality and give you real atr 42 300 320 questions in our Cisco 300 320 arch pdf braindumps.Latest 100% VALID Cisco 300 320 vce Exam Questions Dumps at below page. You can use our Cisco ccdp arch 300 320 pdf braindumps and pass your exam.

Q91. Which technology is an example of the need for a designer to clearly define features and desired performance when designing advanced WAN services with a service provider? 

A. FHRP to remote branches 

B. Layer 3 MPLS VPNs secure routing 

C. Control protocols (for example Spanning Tree Protocol) for a Layer 3 MPLS service 

D. Intrusion prevention, QoS, and stateful firewall support network wide 

Answer:


Q92. To support the enterprise high-availability requirements, which workgroup switch technology can be used to interconnect multiple switches into a single logical unit? 

A. StackWise 

B. EtherChannel 

C. VSS 

D. vPC 

E. Flex Links 

Answer: A


Q93. What are two benefits of using 6to4 as an IPv6 transition method? (Choose two.) 

A. 6to4 tunnels allow isolated IPv6 domains to be remotely connected over IPv4 networks. 

B. Manual configuration (scalability) is easier. 

C. Point-to-multipoint automatic tunneling (automatic 6to4) is available. 

D. An infinite number of address spaces are allocated to an IPv6 subnet. 

E. Globally unique IPv4 addresses are not required. 

Answer: A,C 


Q94. Refer to the exhibit. 

Which statement about the ASA is true? 

A. The management interface is reachable only from VLAN 30. 

B. The management interface is reachable only from VLAN 40. 

C. It is running in transparent mode. 

D. It is running in routed mode. 

Answer:


Q95. In a collapsed core design, which three benefits are provided by a second-generation Cisco MDS director? (Choose three.) 

A. a higher fan-out ratio 

B. fully redundant switches 

C. 100 percent port efficiency 

D. all ISLs contained within a single chassis 

E. higher latency and throughput than a core-edge design switch 

Answer: B,C,D 


Q96. Which option is a method of restricting access for users based on user roles and locales? A. RBAC 

B. ACE 

C. LDAP 

D. RADIUS 

Answer:


Q97. Which protocol is required for end-to-end signaling in an IntServ QoS architecture? 

A. RSVP 

B. DSCP 

C. ToS 

D. LLQ 

E. DiffServ 

Answer:


Q98. Which statement best describes Cisco OTV internal interfaces? 

A. They are Layer 2 interfaces that are configured as either access or trunk interfaces on the switch. 

B. They are interfaces that perform Layer 3 forwarding with aggregation switches. 

C. They are the interfaces that connect to the ISP. 

D. They are tunnel interfaces that are configured with GRE encapsulation. 

Answer:


Q99. A VPN solution requires bulk traffic encryption, low OpEx to add new sites, and the ability to accommodate dynamic tunnels between branch locations. What VPN solution can fulfill these requirements? 

A. GETVPN 

B. SSL VPN 

C. Easy VPN 

D. DMVPN 

Answer:


Q100. When considering the design of the E-Commerce topology which of the following are true? 

A. One-armed SLB design with multiple security contexts removes the need for a separate firewall in the core layer 

B. Two-firewall-layer SLB design considers the aggregation and access layers to be trusted zones, requiring no security between the web, application, and database zones 

C. One-armed SLB design with two firewall layers ensures that non load-balanced traffic still traverses the ACE so that the health and performance of the servers is still being monitored 

D. In all cases there will be configuration requirements for direct access to any servers or for nonload-balanced sessions initiated by the servers 

Answer: